Can read???? i2s taken from it .....sony???? philips????

AKM DAC 4420
# Applications: Set Top Boxes, DVD Recorders/Players, Digital TVs, and AV Receivers
# Sampling Rate Ranging from 8kHz to 192kHz
# 128 times Oversampling (Normal Speed Mode)
# 64 times Oversampling (Double Speed Mode)
# 32 times Oversampling (Quad Speed Mode)
# 24-Bit 8 times FIR Digital Filter
# Switched-Capacitor Filter with High Tolerance to Clock Jitter
# Single Ended 2Vrms Output Buffer
# Digital de-emphasis
# Soft mute
# I/F format: 24-Bit MSB justified or I2S
# Master clock: 512fs, 768fs or 1152fs (Normal Speed Mode)
256fs or 384fs (Double Speed Mode)
128fs, 192fs (Quad Speed Mode)
# THD+N: -92dB
# Dynamic Range: 105dB
# Automatic Power-on Reset Circuit
# Power supply: +4.5 ~ +5.5V
# Ta = -20 to 85°C
# Small Package: 16pin TSSOP (6.4mm x 5.0mm)

да уж!!! трудно объяснить, когда плохо знаешь язык

я разобрался.....уже с этим вопросом...буду пробовать пустить сигнал I2S c этой микросхемы АКМ 4420 с помощью специального модуля RaKK-2

Edited by user Thursday, February 17, 2011 12:24:23 PM(UTC)  | Reason: Not specified

Well I can't blame him, my Russian certainly is worse than his English.
Loosly translated I think it means this:

"It's hard to explain using a language I'm not familiar with."
"I understand ... I will try to run the I2S signal into an AKM 4420 using the RaKK-2 module"

Or something like that... How that relates to the Buffalo DAC is a mystery to me.

No problem, we'll get there. It just takes a little time.

The picture is a bit small, so I can't read everything clearly. But looking at it it seems you are uncertain about how to connect the I2S output of the RAKK board to the BII. That is fairly simple. The I2S wiring for the BII board is on page 6 of the Integration Guide I wrote:
http://www.twistedpearau...tegration_Guide_v1.0.pdf

P.S. I've tried copying the table directly, but the lay-out gets messed up too much.