Brian answered all my questions at diyAudio, thank you very much Brian. I post here to help anybody with the same problem like me

1/ Kit comes with 10 resistors, have I to populate R1-7?

You only need to add resistors for the channels you plan on using (R1 and R2) but there is no harm in adding them all.

2/ What's the power consumption?

Not sure off the top of my head, but <100mA IIRC. I can check but will depend on the clocks you use.

3/ Wich one is channel Left & Right for D1 & D2?

Um, not sure.

4/ What is the 3 holes MCK jumper position set up for DSD using 22,XXX & 24,XXX clocks

MCK+ (works for 99% of applications)

5/ What are the 6 holes HMCK_SEL the jumper position set up for DSD using 22,XXX & 24,XXX clocks

J1:1

6/ Just curiosity. What's the pourpose for 0_D8 & 0_D7 holes?

Access to unused header pins.

7/ I don't use Hermes, what pins have I to use for Cronus input MCK, LRCK, BCK & DATA?

For DSD you only need D1 D2 and DCK. On Amanero that's DCK:BCK(Pin4), D1:FSCK(Pin5), D2ATA(Pin3) ** I think, been a while and I don;t use DSD

Thanks again & best regards
Felipe

Edited by user Tuesday, September 17, 2019 9:10:54 AM(UTC)  | Reason: Not specified

Are there plans to restock these soon?

I ordered an Amanero USB module from the European supplier listed on the Amanero site to get it quickly. Even though every picture shows the Amtel chip with model number ATSAM3U2C the one I received has ATSAM3U1C. I assume there is no functional difference?