Rank: Member
Groups: Member
Joined: 5/6/2009(UTC)
Posts: 27
Location: Washington, DC
|
Hi,
I wondered if I can wire up the SPDIF Receiver module to output SPDIF back to an external connector while also sending PCM on to the Metronome? Reading the manual it seems possible with the recommended default jumper settings. There is a header for SPDIF in and also out. Does the signal go into the receiver, get reclocked, and then back out or is this just a couple of pads connected to the input to allow the original signal to be "split" out?
Either way I would like to pass the signal out of the back of the chassis on to another device. If this works will there be any degradation?
Thanks,
Paul
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/6/2009(UTC)
Posts: 27
Location: Washington, DC
|
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Is this the Wolfson receiver or the MUX?
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/6/2009(UTC)
Posts: 27
Location: Washington, DC
|
This is the USB DAC/Receiver module based on the Texas Instruments PCM2707 USB DAC chip.
Thanks.
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
The USB module does not accept S/PDIF input. Are you sure you are not talking about the WM8804 S/PDIF Transceiver? Edited by user 15 years ago
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/6/2009(UTC)
Posts: 27
Location: Washington, DC
|
Thanks for the reply.
What I want to do is take the PCM output and wire it to my OPUS (I am already doing this now) and at the same time take the SPDIF output and wire it to another outside connector in order to pass through the signal to another device.
In other words can the 2707 send two outputs (SPDIF and PCM) at the same time and not compromise either?
Best,
Paul
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
No, it can only output one or the other.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
