Rank: Member
Groups: Member
Joined: 2/24/2015(UTC) Posts: 9  Location: Haugesund
|
Hi all,
I assume that the O1/O3/O5/O7 (L) is setup as the same signal, with no change from default settings.
And the O2/O4..... is setup as the opposite channel (R).
I do not notice any difference of the output level, when only O1 is used, or all 4 connected together. Normal, or some settings that has to be made ?
Im planning to use my setup for stereo output from one Buffalo III.
Also planning to make an IV stage similar to ESSTec´s recommended circuit, only with the single ended option available. Anyone tried that ?
Cheers
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
The output voltage stays the same, but current increases. You will only notice a difference after covering to voltage.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
