Atom Feed - Twisted Pear Audio Support - Topic:Buffalo III IV stage diy - 20Twisted Pear Audio Support - Atom Feedurn:twistedpearaudio-com:AtomFeed:TwistedPearAudioSupport:Topic:BuffaloIIIIVstagediy-20:1Copyright 2024 Twisted Pear Audio Support2024-03-29T01:28:46Zhttp://www.twistedpearaudio.com/forum/Images/YAFLogo.pngForum Adminhttp://www.twistedpearaudio.comfeedback@twistedpearaudio.comBrian Doneganhttp://www.twistedpearaudio.com/forum/profile/8-Brian-DoneganBrian Doneganhttp://www.twistedpearaudio.com/forum/profile/8-Brian-DoneganSuprted1http://www.twistedpearaudio.com/forum/profile/26370-Suprted1YetAnotherForum.NETurn:twistedpearaudio-com:ftPosts:st1:meid25743:1Buffalo III IV stage diy<table class="content postContainer_Alt" width="100%"><tr><td>The output voltage stays the same, but current increases. You will only notice a difference after covering to voltage.</td></tr></table>2019-09-18T21:20:38-07:002019-09-18T21:20:38-07:00Brian Donegan<table class="content postContainer_Alt" width="100%"><tr><td>The output voltage stays the same, but current increases. You will only notice a difference after covering to voltage.</td></tr></table>urn:twistedpearaudio-com:ftPosts:st1:meid25742:1Buffalo III IV stage diy<table class="content postContainer" width="100%"><tr><td>Hi all,<br /><br />I assume that the O1/O3/O5/O7 (L) is setup as the same signal, with no change from default settings.<br />And the O2/O4..... is setup as the opposite channel (R).<br /><br />I do not notice any difference of the output level, when only O1 is used, or all 4 connected together. Normal, or some settings that has to be made ?<br /><br />Im planning to use my setup for stereo output from one Buffalo III.<br /><br />Also planning to make an IV stage similar to ESSTec´s recommended circuit, only with the single ended option available. Anyone tried that ?<br /><br />Cheers</td></tr></table>2019-09-18T21:13:36-07:002019-09-18T21:13:36-07:00Suprted1<table class="content postContainer" width="100%"><tr><td>Hi all,<br /><br />I assume that the O1/O3/O5/O7 (L) is setup as the same signal, with no change from default settings.<br />And the O2/O4..... is setup as the opposite channel (R).<br /><br />I do not notice any difference of the output level, when only O1 is used, or all 4 connected together. Normal, or some settings that has to be made ?<br /><br />Im planning to use my setup for stereo output from one Buffalo III.<br /><br />Also planning to make an IV stage similar to ESSTec´s recommended circuit, only with the single ended option available. Anyone tried that ?<br /><br />Cheers</td></tr></table>