Rank: Member
Groups: Member
Joined: 5/10/2015(UTC) Posts: 5  Location: Berkeley, CA
|
I am using the Buffalo-III as a multichannel DAC driving four IVY-III boards. I am not getting quite enough output. 2v should be more than enough to drive the amps I am using. If I am feeding the IVY-III with only a fourth the current than a stereo configuration should I assume that is what is lowering the output? The same question was posted two years ago but there is no response to it: http://twistedpearaudio....ain-resistors-on-IVY-IIIWhat resistor values should I be using in the IVY-III when I am driving each side of the IVY-III with only one channel output from the Buffalo-III? Thank you! Edited by user Tuesday, October 25, 2016 12:41:03 AM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/23/2010(UTC)
Posts: 708
Location: Netherlands
Thanks: 2 times
Was thanked: 48 time(s) in 45 post(s)
|
See the integration guide, page 71.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
