Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Login


Options
View
Go to last post Go to first unread
jameslab  
#1 Posted : Tuesday, October 25, 2016 12:15:49 AM(UTC)
jameslab

Rank: Member

Groups: Member
Joined: 5/10/2015(UTC)
Posts: 5
United States
Location: Berkeley, CA

I am using the Buffalo-III as a multichannel DAC driving four IVY-III boards. I am not getting quite enough output. 2v should be more than enough to drive the amps I am using. If I am feeding the IVY-III with only a fourth the current than a stereo configuration should I assume that is what is lowering the output?

The same question was posted two years ago but there is no response to it:
http://twistedpearaudio....ain-resistors-on-IVY-III

What resistor values should I be using in the IVY-III when I am driving each side of the IVY-III with only one channel output from the Buffalo-III?

Thank you!

Edited by user Tuesday, October 25, 2016 12:41:03 AM(UTC)  | Reason: Not specified

LeonvB  
#2 Posted : Wednesday, October 26, 2016 2:26:06 PM(UTC)
LeonvB

Rank: Member

Groups: Member
Joined: 5/23/2010(UTC)
Posts: 719
Location: Netherlands

Thanks: 2 times
Was thanked: 48 time(s) in 45 post(s)
See the integration guide, page 71.
Rss Feed  Atom Feed
Users browsing this topic
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.