Rank: Member
Groups: Customer
Joined: 10/25/2006(UTC)
Posts: 3
Location: Houston
|
Just stuffed a couple extra TXD modules, but without a drawing or BOM. Used 1K for R1and RF, 2K for R2 and RG. R3 IS 100K. Used 0.47 ufd for the film and 33 ufd for the electrolytics.
What is the value for R0? I found a schematic, but there is not R0 shown.
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Hi!
Which version of the PCB is it?
|
|
|
|
|
|
Rank: Member
Groups: Customer
Joined: 10/25/2006(UTC)
Posts: 3
Location: Houston
|
Well now that you mention it, I have two with R0 and two that do not have a space for R0. Looks like R0 COULD be replaced with a jumper. The boards without look to be older, ligter green, and not much labeling. The ones with are bright green and have the number 336073 on top, and E235512 on the bottom.
For use as a SE to balanced line driver, is jumping R0 the best option?
George
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
If its an R direct to the output then yes, just jumper it. I think its just an output R to help with capacitive loads. :)
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
