Rank: Member
Groups: Member
Joined: 1/20/2014(UTC) Posts: 1  Location: Iowa
|
I purchased a Joshua Tree 1st gen kit a number of years ago and used it at the input of a balanced preamp.(2 relay boards stacked) I did not read carefully enough and discovered it has a 2.2K - 10K input load, and a 750 ohm output impedance. I have sources now that are not going to be happy with that kind of load. Is there any reason that I couldn't use it at the output of a solid state preamp stage that can happily drive a 2.2K load? And..with the 750 ohm output impedance of the Joshua, will the preamp be as happy driving cables and a 10K input on the amplifier as having the preamp output drive it directly without the Joshua in line?
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Sure - you could use a line driver at either end - or both.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
