Rank: Member
Groups: Member
Joined: 5/28/2014(UTC) Posts: 24  Location: Foggia
|
Hello,
I connected my BP Placid stage-III IVY I / V Stage with the following settings:
Voltage: 14.75 V
ccs current: 150mA
ccs shunt: 60 mA
This can be good, or do I have to change some settings of voltage or current?
I connected my placid hd 2.1 to my buffalo dac IIISE with the following settings:
Voltage 5.25 V
ccs current 520mA
ccs shunt 50mA
This can be good, or do I have to change some settings of voltage or current?
Kind regards
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 6/17/2008(UTC) Posts: 921  Thanks: 1 times
Was thanked: 70 time(s) in 69 post(s)
|
Does it play ?
Does it smoke ?
If it plays (and puts out a minimal amount of smoke) you're safe.
Keep an eye on the heat sinks temperature. If it gets "too" hot, trim down the current a bit. Always measure both voltage and current again after the rig has settled to steady state.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 3/8/2011(UTC)
Posts: 136
Location: Norway
Was thanked: 2 time(s) in 2 post(s)
|
Keeping shunt below 60mA is the right thing to do. Then you will not have problems with heatsinks getting to hot.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
