Rank: Member
Groups: Member
Joined: 10/21/2012(UTC) Posts: 11  Location: Sydney
|
Originally Posted by: DQ828  How would the Teleporters be applied given the BIII & RPi would only be inches apart? Whether inches or metres, I'm pretty sure Russ simply means to use the teleporters to block (or reduce) induced noise. Though as I understand it, the teleporters are not actual isolation devices, right? Can I please ask some further questions on this: 1) is the noise that miero measured likely to have a noticeable effect on SQ? 2a) alternative isolation devices, such as those discussed on the diyaudio forum, are known to add jitter, and the convention appears to be to reclock the I2S signals after these isolation devices. Do the teleporters add a similar degree of jitter compared to those other devices, and if so, does the idea of reclocking after the teleporter-receiver have merit? 2b) or does the ES9018's jitter-reduction regime make this unnecessary?
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 10/22/2011(UTC)
Posts: 135
Location: Prague
Thanks: 1 times
Was thanked: 3 time(s) in 3 post(s)
|
Originally Posted by: Twistedpair
1) is the noise that miero measured likely to have a noticeable effect on SQ?
It greatly depends on the amplifier. But surely it is better to not have such noise at the DAC output. Originally Posted by: Twistedpair
2b) or does the ES9018's jitter-reduction regime make this unnecessary?
yes, it has: - http://www.esstech.com/pdf/about-jitter.pdf -
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Originally Posted by: Twistedpair
2a) Do the teleporters add a similar degree of jitter compared to those other devices?
No. Edited by user Thursday, February 20, 2014 2:11:33 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/4/2011(UTC)
Posts: 17
Location: malaysia
|
Can i output pi i2s to a buffalo II with ivy output stage ??
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 10/19/2010(UTC)
Posts: 3
Location: TX
|
Originally Posted by: kp93300 Can i output pi i2s to a buffalo II with ivy output stage ??
I am using the pi's I2S with the Buffalo 2, works great. I have Legato, not Ivy, but I don't think it matters. Eitan
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
