Rank: Member
Groups: Member
Joined: 8/18/2011(UTC)
Posts: 2
Location: here
|
The Placid BP manual says to measure the resistance of the VR1 and 2 pots at the outer pins, however these pins always measure at the full value of the pot. Only pins A+B or B+C respond to an adjustment of the dial. Which should I be measuring?
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
They are installed on the board then they are connected as a rheostat. Which means you can measure across the pins. :)
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 8/18/2011(UTC)
Posts: 2
Location: here
|
Ah, I was trying to measure them off the board - thanks.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
