Rank: Member
Groups: Member
Joined: 5/28/2010(UTC)
Posts: 4
Location: Tokyo
|
I just bought the Toslink module to feed a CS8414. In my DAC (DAC END by Andrea Ciuffoli) there is a transformer at the input. Where is better to connect the module ? Can I leave both the Toslink and the coax connected, obviously not using them at the same time.
Thanks,
Davide
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
I don't know anything about that DAC, but I will suggest you remember that the output of the TORX module is TTL level. You may want to use a resistor divider to get it to consumer level.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/28/2010(UTC)
Posts: 4
Location: Tokyo
|
Thanks, I am still not sure what way to go. The first option is to build just an external TorX to COAX converter. For this application, do you have a reccomanded schematic ? As my spdif receiver supports TTL level signal (RS442), the other option is just to stick the output of the TORX to the CS8414 through a 0.1 nF cap. The only problem is that I do not know if I can leave the COAX in place or not. The input stage is the following: http://picasaweb.google....iers#5477291291688232978Thanks, Davide
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
