Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Login


Options
View
Go to last post Go to first unread
HeadSh0T  
#1 Posted : Monday, February 11, 2008 9:52:26 AM(UTC)
HeadSh0T

Rank: Member

Groups: Member
Joined: 2/11/2008(UTC)
Posts: 10
Location: Toronto, Canada

I'm planning to use the Darwin to use both single ended and balanced inputs and outputs and it'll be used with the JT attenuator. The JT will be placed on the output of my preamp.

I have 2 JT relay boards which should allow for balanced operation but now I'm confused. As I understand it, only 3 out of the 4 inputs and outputs on each relay board is used (2 Ins + gnd, 2 Outs + gnd) in balanced mode with J2 jumpered.. So then how would that work if I've selected a single ended out?

Does this mean I can only use darwin and JT as balanced or single ended exclusively and not both?



Brian Donegan  
#2 Posted : Monday, February 11, 2008 10:08:36 AM(UTC)
Brian Donegan

Rank: Administration

Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA

Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
You want to wire the entire setup as if each input was balanced, so use one Darwin board and one JT relay board per channel. For balanced inputs, wire each input with + GND and -. For SE, just wire + and GND, leaving - empty.

If you want to control volume for both outputs, you can place the JT in the loop out/in of the Darwin boards.
Rss Feed  Atom Feed
Users browsing this topic
GuestUser (2)
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.