Rank: Member
Groups: Member
Joined: 9/26/2007(UTC)
Posts: 1
Location: West Chester, PA USA
|
I was considering mounting the pot in a small, remote box wired back to the JT controller, possibly using an XLR connector and microphone cable. I'm thinking that mounting a small additional cap (0.1uF?) at the board end of the "extended pot" would minimize possible noise/jitter.
Does anyone experience or thoughts on this?
Many thanks! - Ted
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
I made an extended harness for a customer who was using his JT in a car install. It was mounted in the back of the car, controlled by a pot in the dash. The cable I made was three 24ga wires twisted with a drill, 16ft long. It worked fine with no modifications to the circuit.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
