Twisted Pear Audio Support
»
Product Support
»
Digital
»
Buffalo DAC
»
How to set up the Buffallo II as voltage output ?
Rank: Member
Groups: Member
Joined: 2/8/2009(UTC)
Posts: 22
Location: Hong Kong
|
Hi, Brian,
Just received the Buffallo II. It looks to arrive in good shape and good packing.
I read from your manual and I would like to start off with voltage output first. I am wondering how I can configure it as voltage output. I am planning to use an output transformer. Is it that I need to put across a resistors on the output such that there is 195 ohm (as a resultant together with the resistance of the primary coil of the output transformer) at the output of the Buffalo.
Thanks in advance.
Alan
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
It is a differential voltage output of around 3.1Vpeak with 195ohms output impedance. It has common mode offset of AVCC/2.
I don't know enough about your transformer to answer the rest of your question. I don't use transformers much so I may not be the best qualified to answer. :)
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 2/8/2009(UTC)
Posts: 22
Location: Hong Kong
|
I will be using the Lundahl LL1676 in a 2:1 configuration. I will let you know the result later. But it will be some time before I source all the necessary components such as the case, connectors, wires and transformer.
|
|
|
|
|
|
Twisted Pear Audio Support
»
Product Support
»
Digital
»
Buffalo DAC
»
How to set up the Buffallo II as voltage output ?
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
