Rank: Member
Groups: Member
Joined: 11/9/2007(UTC)
Posts: 453
Location: usa
|
Hi Russ, Brian.
Wanted to use the s/w interface f the WM884 v1 but I noticed that pin 3 is connected directly to gnd. Is there anyway to connect this to VDD besides cutting that leg of the chip?. I notice that in V2 pin 3 is connected to a resistor.
Thanks.
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
It was designed for hardware mode. So you would have to do some surgery.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 11/9/2007(UTC)
Posts: 453
Location: usa
|
Bummer. Is lifting the leg the only way or is it connected to GND some other way (via/trace). Those legs are SMALL!
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
It's connected to a GND plane under the chip, so you would have to lift it.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
