l have a Buffalo II fed by a WaveIO USB module. It sounds great, except for occasional static pops that occur when I touch the enclosure or when people walk around on the carpet in the living room. While it is sitting on top of a power conditioner, the enclosure has rubber feet and leads me to believe the issue is coming in through the USB cable. The USB module is fed by an Ultrarendu that has a separate power supply. The WaveIO is powered by the LCDPS power supply, which is also used to power the Buffalo DAC.

I've attached a picture of the DAC. I have grounded the AC inlet to the body of the enclosure and have also grounded the DAC's ground to the body of the enclosure via a wire that screws down to the baseplate of the USB module. I usually run the DAC with balanced outs and the ground of the XLR outputs and single-ended outputs are all connected to the ground channel of the IVY.

Any advice on how to solve this problem would be much appreciated. I recently got a much more powerful amp and speakers and am worried about damaging them.

Thank you. IMG-1162.jpg (217kb) downloaded 36 time(s).

Edited by user Tuesday, October 29, 2019 3:56:43 PM(UTC)  | Reason: Not specified

Hi steward,

I had the same. When flipping a light switch a pop was heard. Just as you do I use a Waveio.
I did hours and hours of troubleshooting. I even changed the light switch.

Eventually I found out I hadn’t grounded the usb receiver housing of the waveio sufficiently to the chassis. It looks like you haven’t as well.
I see u do use the grounded screw hole for the chassis stud.

The chip for the isolated ground died twice. I’m also using the u.fl connectors now. But maybe it’s an option for you to use the isolated outputs .

Hope it helps.

Jordo

Edited by user Saturday, January 18, 2020 11:37:38 PM(UTC)  | Reason: Not specified