Rank: Member
Groups: Member
Joined: 12/6/2009(UTC)
Posts: 323
Location: Catalonia new Europe state
Thanks: 4 times
Was thanked: 1 time(s) in 1 post(s)
|
Mine friend Antonio bought a 2nd hand B3 with volume control installed, I want to take off the volume control so I desoldered the pot and take off the firmware installed in IC8 but can't output sound, I owned a B2 and if I remember correctly a bridge was needed between ADC pins but I don't remember between wich one 3.3V & PB4 or PB4 & GND also I don't know if this is necessary for B3?
TIA
Felipe
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Jumper between PB4 and 3.3. You also need the firmware chip installed.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 12/6/2009(UTC)
Posts: 323
Location: Catalonia new Europe state
Thanks: 4 times
Was thanked: 1 time(s) in 1 post(s)
|
Many thanks Brian, If I desolder the pot and take off the firmware chip is the same?
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
No, the firmware is required to configure the DAC. Providing volume control is just one of its functions.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 12/6/2009(UTC)
Posts: 323
Location: Catalonia new Europe state
Thanks: 4 times
Was thanked: 1 time(s) in 1 post(s)
|
OK thank you for support.
Bst
Felipe
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
