Rank: Member
Groups: Member
Joined: 12/1/2012(UTC) Posts: 16  Location: Stockholm Thanks: 9 times
|
Hi Russ or Brian. Maby a stupid question but...  If you do like i have done and run one IVY with two Buffalo III DACs. Using two Placid BPs to power left and right balanced channel on the IVY leaving the SE stage unused. Now there is jumpers to power a single IVY using a Placid BP, right? In my current config in dual mono with no SE channel. Can you use those jumper points with som type of diode instead of jumpers. So you redirect exess power from both left and right balanced channel to the SE one. Without mixing left and right channel togehter and still maintaining dual mono with the SE stage working also. But with only two Placids instead of three? 
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
No - you really can't use a diode like that - it will end up basically always going through one - you would be best off just to use one supply or three if you want to use the SE stage. Not two.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
