Rank: Member
Groups: Member
Joined: 4/7/2009(UTC) Posts: 19  Location: Spain Thanks: 1 times
|
Hi all,
I would like to test the analog output (a tube buffer) of my DAC (two Bufalo II in dual mono operation). I need to inject a sine and a square signal at the input of the analog stage (and output of the Buffalo), but I prefer not desoldering both stages because it is a little mess. Could the buffalo be damaged if I inject a signal (sine and square wave with a signal generator) at its output?
Also I would like to know the output impedance of the Buffalo in mono operation.
Thanks and regards,
Francisco
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 4/7/2009(UTC) Posts: 19 Location: Spain Thanks: 1 times
|
No responses... Come on guys, could someone give any help?
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
I think you would be better off testing without the Buffalo connected, as it will influence the signal you are inputting. I don;t think it will cause any damage, but better safe than sorry.
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Output impedance depends on the way the outputs are connected.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
