How to select Voltage mode or current mode? Options  Watch this topic  Print this topic  Atom Feed  RSS Feed View » Normal Threaded

Previous Topic Next Topic

topanw		#1 Posted : Wednesday, June 11, 2014 2:44:51 AM(UTC)
Rank: Member Groups: Member Joined: 4/23/2014(UTC) Posts: 7 Thanks: 3 times		I bought buffalo iii SE so I hope test voltage and current mode but I don't know how to select Please give me advice Thank you very much June
User Profile View All Posts by User View Thanks

	Wanna join the discussion?! Login to your Twisted Pear Audio Support forum accountor Register a new forum account.

Brian Donegan		#2 Posted : Wednesday, June 11, 2014 3:13:29 AM(UTC)
Rank: Administration Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)		There isn't really a current mode nor voltage mode. "Mode" is not a good description. "Source" is a better term. The DAC can either act as a current source (when presented with a near-zero ohm load) or a voltage source (when resented with a higher impedance load).
		WWW
1 user thanked Brian Donegan for this useful post.		topanw on 6/11/2014(UTC)
User Profile View All Posts by User View Thanks

topanw		#3 Posted : Wednesday, June 11, 2014 5:20:14 AM(UTC)
Rank: Member Groups: Member Joined: 4/23/2014(UTC) Posts: 7 Thanks: 3 times		Hello Brian Thanks to advice~! so no need any setting on DAC. The source is just according to load(near-zero ohm or higher impedance) Is it right? Edited by user Wednesday, June 11, 2014 5:21:14 AM(UTC)  | Reason: Not specified
User Profile View All Posts by User View Thanks

avr300		#4 Posted : Wednesday, June 11, 2014 5:52:21 PM(UTC)
Rank: Member Groups: Member Joined: 6/17/2008(UTC) Posts: 921 Thanks: 1 times Was thanked: 70 time(s) in 69 post(s)		Yes, that's correct.
User Profile View All Posts by User View Thanks

DQ828		#5 Posted : Wednesday, June 11, 2014 10:14:12 PM(UTC)
Rank: Member Groups: Member Joined: 8/17/2010(UTC) Posts: 368 Location: australia Thanks: 8 times Was thanked: 3 time(s) in 3 post(s)		Originally Posted by: avr300 Yes, that's correct. At what point impedance wise does it change over, I assume there is a twilight zone where it's sort of in between the two.
User Profile View All Posts by User View Thanks

Brian Donegan		#6 Posted : Thursday, June 12, 2014 12:10:11 AM(UTC)
Rank: Administration Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)		There is no transition point. Well, there is, actually: 0-ohms.
		WWW
User Profile View All Posts by User View Thanks

Rss Feed  Atom Feed

Users browsing this topic

GuestUser (4)