Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Ok, your LEDs are not lighting because your AVCC pins are not properly soldered to the Buffalo board. I see solder on the pins, but it is not flowed onto the Buffalo pads. Please add some flux and reheat those joints. It appears you may be using too much heat and not enough flux when soldering.
Also, if you want to use stereo mode, you need to all ALL of the output jumpers, which is also outlined in the Integration Guide, which you really should read. Run it through Google Translate if you need to, but please please read it.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 4/19/2012(UTC)
Posts: 46
Location: italia
Thanks: 1 times
|
Hi, i have read your ingration guide ,
I do not understand what it means to connect "all the jumpers" I'm afraid of doing damage,
I need a picture where I can look at what to do?
I'm sorry for my ignorance but I thought I experience something more 'simple.
Please we hope to end ...... tell me what to do ...
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/23/2010(UTC)
Posts: 708
Location: Netherlands
Thanks: 2 times
Was thanked: 48 time(s) in 45 post(s)
|
The procedure is outlined on page 23. It even directs you to the picture on page 5 which clearly outlines the jumpers. You need to solder the jumpers J1 to J12 in place.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
