Buffalo Board R 17 Options  Watch this topic  Print this topic  Atom Feed  RSS Feed View » Normal Threaded

Previous Topic Next Topic

Erlend Sæterdal		#1 Posted : Saturday, October 8, 2011 3:09:59 PM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		On my Buffalo II board R17 is missing. Any special reason for that ?
User Profile View All Posts by User View Thanks

	Wanna join the discussion?! Login to your Twisted Pear Audio Support forum accountor Register a new forum account.

Russ White		#2 Posted : Saturday, October 8, 2011 6:16:25 PM(UTC)
Rank: Administration Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 3,979 Location: Nashville, TN Thanks: 25 times Was thanked: 89 time(s) in 83 post(s)		Do you mean R7? R7 is normally not populated. It is used to set an alternate address for the port expander in special cases.
		WWW
User Profile View All Posts by User View Thanks

Erlend Sæterdal		#3 Posted : Sunday, October 9, 2011 12:39:42 AM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		No Russ I mean R17 just beside the Crystal.
User Profile View All Posts by User View Thanks

Erlend Sæterdal		#4 Posted : Sunday, October 9, 2011 1:10:51 PM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		Could be nice with an answer I am 80 % finnished with my Dacpre. Is that resistor needed or what ?
User Profile View All Posts by User View Thanks

Russ White		#5 Posted : Monday, October 10, 2011 10:21:48 AM(UTC)
Rank: Administration Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 3,979 Location: Nashville, TN Thanks: 25 times Was thanked: 89 time(s) in 83 post(s)		Ah, I misundertood at first I thought you were talking about Bufallo III which has no R17. :) As for R17 on Buffalo II, No it not necessary nor should it be populated. It is there for when the clock is omitted and you wish to use a plain crystal.
		WWW
User Profile View All Posts by User View Thanks

Erlend Sæterdal		#6 Posted : Monday, October 10, 2011 1:51:20 PM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		Okay :d/ Thank you very much than I am ready to finnish it during the week.
User Profile View All Posts by User View Thanks

Rss Feed  Atom Feed

Users browsing this topic

GuestUser (5)