Hi there guys, I should have my dual mono Buff32 with mux, running optical, coax (BNC and RCA) and AES, with a view to tapping DSD or i2s from my RME9632. the kit will be arriving sometime shortly. I would like to be able to use XLR to drive headphones directly (balanced HD600 and woody D2000), as well as output balanced to my KRK active monitors. possible?? I would ideally also be able to drive my Lisa III or other SE headphone amp as well. is the ability to drive headphones direct with the IVY and driving a load like the monitors mutually exclusive?? do I cut the resistor trace in this case?? I would prefer to use the same outputs if possible, to keep impedance in check; instead of wiring in a duplicate line to a separate set of XLRs that bypass the resistor

please excuse the noob question, while i'm not a total beginner at DIY, I have never dealt with a circuit like this as most of my experience is with cables/headphones/docks/DIYMODS; apart from a gamma1

thanks in advance

Edited by user Tuesday, August 4, 2009 6:08:34 AM(UTC)  | Reason: Not specified