Rank: Member
Groups: Member
Joined: 12/7/2011(UTC)
Posts: 474
Location: Amsterdam
Thanks: 31 times
Was thanked: 4 time(s) in 3 post(s)
|
I found 4 different resistor values enclosed with the Mercury for R1 and R2. Which will I use when I use the Mercury in combination with the 9038 BIII SE? Edited by user Sunday, May 16, 2021 4:16:40 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
The four sets of resistors are for the following configurations:
ES9018/9028 @2V: 243R
ES9018.9028 @4V: 499R
ES9038 @2V: 60R4
ES9038 @4V: 121R
For the 9038, 60R4 would be typical, or 121R is your next stage can tolerate 4V input.
|
 1 user thanked Brian Donegan for this useful post.
|
|
|
|
Rank: Member
Groups: Member
Joined: 12/7/2011(UTC)
Posts: 474
Location: Amsterdam
Thanks: 31 times
Was thanked: 4 time(s) in 3 post(s)
|
Thank you Brian, I will contact Hypex to see what the NC400 requires. If 4V is accepted, will it hold advantage over lower voltage? What would you recommend? Thank you. Jordo Edited by user Sunday, May 16, 2021 9:35:52 PM(UTC)
| Reason: removed question about IVY output voltage
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 12/7/2011(UTC)
Posts: 474
Location: Amsterdam
Thanks: 31 times
Was thanked: 4 time(s) in 3 post(s)
|
2Vrms it is according to Hypex so I will install the 60R4 resistors. Thanks! Edited by user Monday, May 17, 2021 5:02:50 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
