Rank: Member
Groups: Member
Joined: 5/25/2018(UTC)
Posts: 1
|
I just accidentally exposed the left channel of my buffalo dac to 20vDC and killed it. I can't believe that just happened, $500 down the drain. Is there a repair service offered by TP? Edited by user Friday, May 25, 2018 3:51:20 AM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 8/5/2012(UTC) Posts: 208  Thanks: 4 times
Was thanked: 16 time(s) in 14 post(s)
|
If you only fried the DAC you can replace it yourself if you're handy with a soldering iron - no special gear needed. I use ChipQuik for the desoldering. Its relatively easy once you learn the technique - or buy a replacement chip on Ebay and pay someone else to do it.
But it depends where you applied the over-voltage - if it was on VD in then you likely fried a bunch of stuff. Do the tridents still work? If so you may be in luck. If not then think of it as an opportunity to ugrade :-)
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
