Rank: Member
Groups: Member
Joined: 1/6/2016(UTC) Posts: 3  Location: Kiel
|
i need some help with the amanero/hermes/cronus/rhea. i put all components together, flashed the amanero in slave mode - set the configuration bits... and nothing... daphile and windows found the device, but no sound. i checked all multiplier jumper, resistors, cables, conf. bites - nothing.
i got 2 amanero boards - no board was running in the setup. then i try to use the hermes without cronus. in normal mode an in slave mode... no sound. any ideas?
kind regards
limbik 5
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 1/6/2016(UTC) Posts: 3 Location: Kiel
|
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 1/6/2012(UTC)
Posts: 305
Location: Plainfield, IL
Thanks: 11 times
Was thanked: 26 time(s) in 21 post(s)
|
Like this?  Resistors in R1-R7 (either SMD or through hole resistors)? Slower clock in X1? Jumper set to 1:2?  Stacked like this?  Edited by user Wednesday, January 13, 2016 6:30:30 AM(UTC)
| Reason: Not specified |
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 1/6/2016(UTC) Posts: 3 Location: Kiel
|
Hello! Yes... just like you! can i check the hermes an Cronus seperatly without an osci? When i only use the hermes for a function test.... do i need an 3.3V power supply for the clean side? normally it should be possibe to connect the isolated output from the hermes to my dac... can i do the same with the cronus? directly th the amanero an than into the dac? if it is possible i can find out whats not workling... i was not sure about the i2s output from the cronus. can you pls give me the right pins for sdata, bckl, gnd and LRSKl? after reading over 400 postings... i still was not sure. Thx a lot and kind regards Edited by user Sunday, January 31, 2016 6:31:56 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Sorry for the late reply - did you get it sorted?
Cronus output is marked for GND,DCK(BCK),LRCK(D1),Data(D2).
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
