Rank: Member
Groups: Member
Joined: 8/4/2008(UTC) Posts: 17 Location: Maryland
|
I am considering buying a Buffalo to use as a DAC between my Squeezebox 3 and Naim amplification. I assume I will need the following :- Buffalo DAC module, IVY I/V or similar. Power supply for Buffalo and power supply for I/V. Not sure about whether current or voltage ? I would be using SPDIF (75 ohm co-ax) in and then RCA out to the preamp. Is this all I will need ? Appreciate your thoughts.
Colin
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 3,979 Location: Nashville, TN
Thanks: 25 times Was thanked: 89 time(s) in 83 post(s)
|
You would need:
Hi Colin,
Bufallo + LCDPS (or similar) running 6.5(suggested) at the outputs. IVY + LCBPS (or similar) running +/- 15V.
You can wire from the SPDIF jack directly to the buffalo.
Buffalo draws ~50ma on VD and ~175ma on VA.
IVY draws ~50ma idle from both supplies.
You should not need anything else except two dual secondary transformers like the ones we carry. :)
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.