Rank: Member
Groups: Member
Joined: 8/15/2013(UTC)
Posts: 3
|
hello, as I have ordered a bare pcb, it turned out that 3 pole DIP switch is quite difficult to get and ordering this only part from Mouser and shipping to Europe, simply doesn't worth it. Is it possible to presolder some wire if I need is2 on the output and will be using the board with TDA1541 dac? Manual says AIF/MS and AIFCONF0 should be "1", does is mean that 1 and 4 pins should be connected to "+" from one side and to 74AC240SC from the other side according to DIP switch manual? thanks in advance!
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 8/15/2013(UTC)
Posts: 3
|
is that correct? 
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
You can definitely use wire instead of the switch.
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 8/15/2013(UTC)
Posts: 3
|
many thanks!
just to confirm, is the above picture correct for i2s output for TDA1541?
thanks in advance!
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
I am not really sure - just refer to the manual and that DAC's data sheet. In any case it should be pretty easy to change settings if you need to.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
