Rank: Member
Groups: Member
Joined: 5/2/2013(UTC) Posts: 1  Location: songkhla
|
I need help to diagnose the problem with my buffalo III se setup. I feed IIS signal from Philip CD pro2 transport to Metronome module and get 64fs out(confirmed by measure) for Baffalo. But there was no sound coming out from the DAC with Legato IV stage. It could get sound normally when feeding by SPDIF. The SW2/6 and SW2/5 were on so sabre should in auto mode. When I feeded with IIS I also disconnected SPDIF. So what went wrong with my set up for IIS to Buffalo and how to do proper set up for IIS input.
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
In order to toggle between the S/PDIF input and I2S input, you need to use the IP_S pads. When left open, S/PDIF is selected. When shorted, I2S is selected. You can use a simple toggle switch, or a microcontroller of some sort to do the switching.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
