Rank: Member
Groups: Member
Joined: 11/9/2008(UTC) Posts: 21 Location: Israel
|
Thanks. However, I don't see in its schematic diagram DO – only Out 1, 2, 3, 4 which are VOUTR, VOUTL and 2 grounds. Or is the DO assigned to 1 of the I2S lines?
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA
Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 11/9/2008(UTC) Posts: 21 Location: Israel
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 1/10/2008(UTC) Posts: 3 Location: Berkeley
|
I've been unsuccessful at getting the Usb module to work with the Buffalo as I2S. If I connect it for I2S as suggested below, I never get any sound or LED lock. If I switch the connection to the 2 wire S/PDIF connection, it works well. Can you make any suggestions as to how to troubleshoot this?
thanks
amacrine
There are two ways you can connect the USB module to the Buffalo: I2S or S/PDIF.
To use I2S, set the jumper on the USB module to I2S, the S/PDIF switch on the Buffalo to off (the side marked "1"), and switch 1 on the Buffalo to "-". Then make the following connections:
USB BCK -> Buffalo DCK USB LRCK -> Buffalo D1 USB DO -> Buffalo D2 USB GND -> Buffalo G
To use S/PDIF, set the jumper on the USB module to SPDIF, the S/PDIF switch on the Buffalo to "On", and switch 1 on the Buffalo to "+". Then make the following connections:
USB DO -> Buffalo SPDIF USB GND -> Buffalo G
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA
Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)
|
What version is your Buffalo?
|
|
|
|
Rank: Advanced Member
Groups: Member
Joined: 12/28/2008(UTC) Posts: 48 Location: Pax River MD
|
is using the USB output as I2S inherently better mode than using the USB output as SPDIF? Will one be better than the other with regards to PC noise floor?
|
|
|
|
Rank: Member
Groups: Member
Joined: 1/10/2008(UTC) Posts: 3 Location: Berkeley
|
my buffalo is version 1.1
|
|
|
|
Rank: Member
Groups: Member
Joined: 1/10/2008(UTC) Posts: 3 Location: Berkeley
|
I guess my question is also the same as the one above, I cant seem to get the USB I2s to work, but the Spdif works well. Is there a benefit to getting the I2s to work? Or is the spdi/f just as good?
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.