Rank: Member
Groups: Member
Joined: 3/23/2010(UTC)
Posts: 53
Location: Germany
Thanks: 1 times
|
Hi,
what ist the power comsumption of the Mux board.
And do the I2C line have to be 3.3 v so that i would need level conversion from arduino pin or could it be also apron. 5 V (arduinio without level conversion)?
thx
Branko
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Power consumption will be <45mA @ 192kHz. There is no I2C interface. You will need to use GPIOs for the two control pins. They are limited to 3.3V, but you can simply build a voltage divider with a pair of resistors for each pin, which will also act as a pull-down, so you only need to switch high. Edited by user Friday, February 1, 2013 9:14:50 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
