No output signal. Options  Watch this topic  Print this topic  Atom Feed  RSS Feed View » Normal Threaded

Previous Topic Next Topic

Erlend Sæterdal		#1 Posted : Friday, October 21, 2011 8:52:26 AM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		The Dac locks on the Spdif input but there is no signal out of the dac. Both voltages for DVCC and AVCC are ca. 5.1 V. I use the volumite with seperate supply. Any ideas what is wrong ? The Spdif switch is " on ". I use a pulse trafo at the spdif input.
User Profile View All Posts by User View Thanks

	Wanna join the discussion?! Login to your Twisted Pear Audio Support forum accountor Register a new forum account.

Brian Donegan		#2 Posted : Friday, October 21, 2011 8:59:15 AM(UTC)
Rank: Administration Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)		Which version of the Buffalo is this? When you say DVCC and AVCC are 5.1V, you mean the input voltage?
		WWW
User Profile View All Posts by User View Thanks

Erlend Sæterdal		#3 Posted : Friday, October 21, 2011 9:06:37 AM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		Buffalo II . 5.1 V is into the Tridents. I will try to use the Dac without the Volumite later to see if that helps. The firmware is on the volumite. I will change that also. After a rest I will be back.
User Profile View All Posts by User View Thanks

Erlend Sæterdal		#4 Posted : Friday, October 21, 2011 10:42:56 AM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		When I do not use the Volumite there is output signal ! I have to check if I have coupled the Alps pot correct. It is a bit special the pot I use.
User Profile View All Posts by User View Thanks

Erlend Sæterdal		#5 Posted : Friday, October 21, 2011 11:00:44 AM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		Do not seem to be any problem with my Alps pot. The two 10 k. decks are parallel. Anything must be reset ?
User Profile View All Posts by User View Thanks

Brian Donegan		#6 Posted : Friday, October 21, 2011 11:06:38 AM(UTC)
Rank: Administration Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)		Errr, what Alps pot?
		WWW
User Profile View All Posts by User View Thanks

Erlend Sæterdal		#7 Posted : Friday, October 21, 2011 11:17:43 AM(UTC)
Rank: Member Groups: Member Joined: 7/27/2008(UTC) Posts: 158		Alps motorized pot instead of the supplied pot ! Found another firmware for the volumite and now it works. Sorry for disturbing you. Edited by user Friday, October 21, 2011 11:18:41 AM(UTC)  | Reason: Not specified
User Profile View All Posts by User View Thanks

Rss Feed  Atom Feed

Users browsing this topic

GuestUser (2)