Rank: Advanced Member
Groups: Member
Joined: 5/4/2011(UTC)
Posts: 34
Location: Southbury, CT, USA
|
Hi Russ,
I have boards to build an attenuator similar to the Joshua Tree and would like to control the relays for that board using the volumite.
1) Will I get the source code if I buy the firmware for the Joshua Tree?
2) How much memory space is left for added programming?
I know there are a few using Arduino.
If the pot in the volumite provides a voltage to the ATtiny based on the pot position and an ADC in the ATtiny converts it into a 8 bit number. Then I was hoping to try and tag on IR receiver code to control a motorized pot. The motorized pot would replace the volumite pot.
Comments?
Thanks.
Simmonds Mathews
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 5/23/2010(UTC)
Posts: 708
Location: Netherlands
Thanks: 2 times
Was thanked: 48 time(s) in 45 post(s)
|
|
|
|
|
|
|
Rank: Advanced Member
Groups: Member
Joined: 5/4/2011(UTC)
Posts: 34
Location: Southbury, CT, USA
|
Thanks.
It would be easier, but not optimized to a single system. The joshua tree setup is perfect for my needs, the only missing part being the IR remote. There are 2 extra pins from the ATtiny that can be used for the motor. The code part would be the hardest part, but maybe not insurmountable.
Simmonds
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
