Rank: Member
Groups: Member
Joined: 7/17/2007(UTC)
Posts: 5
Location: Philly, PA
|
Hey Russ/ Brian --
Could one of you point out the 'load balancing resistor' section of the Ballsie for those who'd like to try load balancing resistors with the dual mono Opus but not purchase the Ballsie module? Thanks.
Regards,
John
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Sure, they are the 47R resistors naed Ri1 - Ri8.
The value is not too critical 10R to 221R should be fine.
Cheers!
Russ
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 7/17/2007(UTC)
Posts: 5
Location: Philly, PA
|
Thanks Russ. I was thinking Ri1-Ri8, but I wasn't sure if RZ1-RZ4 were a part of that or not.
Regards,
John
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Those resistors Ri1-8 along with RZ1-4 will set the input impedance of the circuit. So in a way they related, but the resistance of Ri is so much lower than that of Rz that its not critical to the calculation.
Cheers!
Russ
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
