Rank: Member
Groups: Member
Joined: 10/21/2010(UTC)
Posts: 21
Location: Kyoto
|
Hi,
My Volumite controller chip works only in "stereo mode".
Without Volumite, I can sucsessfully select "stereo mode" "(dual)mono mode" with on-board controller.
With Volumite, "stereo mode" and volume controling are no probrem, but I cannot enter "mono mode".
Volumite controller chip ignores dip switch on/off.
* Of course I2C header is connected, PB1 is connected to GND and DAC's on-board controller removed.
Any solutions? or my Volumite controller chip itselves have problem?
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 10/21/2010(UTC)
Posts: 21
Location: Kyoto
|
Solved. I'd forgotten jumper ADDRESS, and my major fault was I was too lazy to wiring between dac-volumite and setting dip switches WHILE DACS ARE RUNNING  Feeding power to the dacs after correct wiring and dip switch settings, they start running as dual mono mode correctly. I have one IVY III module and one another I/V conversion board, so I had tested dual mono mode using IVY III by simply pararelleling R+/L-, R-/L+ on each Buffalo II.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
