Rank: Member
Groups: Member
Joined: 2/17/2007(UTC)
Posts: 45
Location: france
|
about the kit's heat sink of the regulator:
with the holes in the sink, the chip is mounted either to high on the top hole and wires don't even touch PCB, or in the middle hole, it is too low, i.e. the bottom part of the chip is beyond the heat sink. any advice is appreciated. thanks!
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Use the lower mounting hole. Only a small portion of the regulator is not in contact with the heatsink.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
