Twisted Pear Audio Support
»
Product Support
»
Power
»
Placid Power Supplies
»
Initial Resistance setting for VR4 with Placid Version 2.0
Rank: Member
Groups: Member
Joined: 11/21/2010(UTC)
Posts: 10
Location: Evanston, Illinois
|
I am building a Placid Version 2.0 and I just finished populating the board. The manual states that before applying power to the board VR4 should be adjusted to its maximum resistance which should be ~10K. I think that the max for my VR4 is 9.53K because the number does not change after about a half a turn. I don't want to keep turning the screw to see if I can get to 10K because in reading the forum it seems that over-turning the screw can damage the pot. So, at the risk of asking a very dumb question, is 9.53K approximately 10K?
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
That is perfectly fine. The "~" means "something close to". 9.53K is definitely close enough. :) Edited by user Tuesday, December 7, 2010 6:13:39 AM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 11/21/2010(UTC)
Posts: 10
Location: Evanston, Illinois
|
Russ, thank you for the quick response.
|
|
|
|
|
|
Twisted Pear Audio Support
»
Product Support
»
Power
»
Placid Power Supplies
»
Initial Resistance setting for VR4 with Placid Version 2.0
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
