a few questions to begin my first post here:

Will the new modules (or, some of them at least) be ready in time to ship out for christmas?

If I wanted to use the Pogo (when it becomes available) as a preamp for the Twisted X Power Module (the basic SE config), would I have to control it with the Uber or can it be used standalone?

also, if I wanted to later add an Opus DAC with a toslink input to the same single-ended system, would I also need the Ballsie?

I know there are probably a fair bit of considerations for this setup, such as power supplies for it all, so if you have any light to shed on powering it all as a whole project would be concerned, I'd appreciate it, since I'm learning as much as I can to get over the "newb" stage.

Thanks in advance,

-Jared P.