Rank: Advanced Member
Groups: Member
Joined: 12/7/2008(UTC)
Posts: 47
Location: Netherlands
|
Hi all, Questions: could sympatico be paralelled straight forward? (2symp.one channel)? if so: transformer requirements/channel? input configuration? still balanced? ballast resistance on output?(or need of servo) Gerard Edited by user Friday, June 11, 2010 3:51:31 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
It is very likely possible. But I have not personally tried it.
I would definitely use load balancing resistors.
A servo might also work, but is more demanding.
I would just increase the transformer by 50% or so. it really depends an how much current your planning on using.
|
|
|
|
|
|
Rank: Advanced Member
Groups: Member
Joined: 12/7/2008(UTC)
Posts: 47
Location: Netherlands
|
Oke transformer capability and output configuration are not the most important questions here. I think.
I am more concerned about the input side........impedance and balanced signals. Will the input impedance not be halved? And how to connect balanced input?
Gerard
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
The input impedance is high enough it should not be a problem. It will go from about 100K to about 50K. :)
Just wire direct to both.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
