Rank: Member
Groups: Member
Joined: 10/11/2009(UTC)
Posts: 13
Location: Bermuda
|
Hi, I have an assembled Buffalo32s that I'm using in a setup with two monoblock amps and I understand from the manual that some traces should be cut (the ones circled in red in the manual). I'm not sure how to tell whether that has been done or not or exactly what to do if not. I have an image of what it looks like now but can't figure out how to paste it into this post. Could someone give a helping hand with either? Cheers Will Edited by user Saturday, May 1, 2010 3:05:49 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
Its pretty easy to tell if you have made a good cut. If you have a multimeter just measure the resistance across each of R51-R54. If they are about 22R then you made a good cut. If it is 0R then it needs bit more work. Oh, and posting a picture is pretty easy, it's just not intuitive, have to click on the "attach" button on the upper right of your post after you have posted it. Cheers! Russ Edited by user Saturday, May 1, 2010 3:20:43 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 10/11/2009(UTC)
Posts: 13
Location: Bermuda
|
Thanks Russ .... but for the life of me I can't find R51 and R54 - even on the layout diagram. Can you point me to where on the board they are? Sorry ...... I see them on a picture I dug up in the Projects section - they are on the underside of the board which I couldn't see when assembled. I'll try to measure them tomorrow. Edited by user Saturday, May 1, 2010 6:37:54 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN
Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
|
They are on the bottom of the board near the output terminals.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
