Twisted Pear Audio Support
»
Product Support
»
Digital
»
Buffalo DAC
»
Questions on the 2 Trident 3.3 Volt regulator supplied with Buffalo III SE Pro
Rank: Member
Groups: Member
Joined: 2/8/2009(UTC) Posts: 22 Location: Hong Kong
|
Hi, I just received the Buffalo III SE Pro board with the 2x Trident 3.3 Volt supply. From my understanding, the VD is powering both the Trident. I have the following questions. 1) is each Trident powering the left channel and another Trident powering the right channel of the ES9038pro chip ? 2) I am going to remain using all the supplied regulators of the kit. But I would like to have separate VD (5V) to power each Trident separately. Is that possible ? Alan Edited by user Tuesday, April 20, 2021 6:32:21 AM(UTC)
| Reason: Not specified
|
|
|
|
Rank: Member
Groups: Member
Joined: 2/8/2009(UTC) Posts: 22 Location: Hong Kong
|
Hi,
I have studied the board in more detail. I asked the wrong question above. I am referring to the dual AVCC 3.3V regulator instead of the two 3.3V Trident. Also I figured that I can remove that particular jumper pin marked as 'in' to the AVCC module and then I can connect separate 5V power supply to those two 'in' to achieve separate supply to the left and right AVCC regulator.
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA
Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)
|
That is correct. Make sure you shared grounds.
|
|
|
|
Twisted Pear Audio Support
»
Product Support
»
Digital
»
Buffalo DAC
»
Questions on the 2 Trident 3.3 Volt regulator supplied with Buffalo III SE Pro
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.