Rank: Member
Groups: Member
Joined: 7/28/2020(UTC) Posts: 3
|
Hi, I have the Buffalo iiise 9038 pro powered with a Centaur and a 50 VA transformer together with a Mecury IV stage. When I connect SPDIF directly to the SPDIF input on the dac board I get no signal and no lock light. I have measured the output voltage on the Centaur and it is 5.2 V. I have measured the tridents, they are all spot on. The Mercury works as well, I connected an analogue signal and I got sound.
I have checked all connetions. The SPDIF source is reliable and works, The volume is jumpered.
Before I jump to the conclusion that the dac doesn´t work I would appreciate very much if someone could point out if I have missed something or if there is something else in the troubleshooting I can do. I may have missed something regarding the firmware settings.
Many thanks in advance!
|
|
|
|
Rank: Member
Groups: Member
Joined: 7/28/2020(UTC) Posts: 3
|
|
|
|
|
Rank: Advanced Member
Groups: Member
Joined: 7/22/2009(UTC) Posts: 81 Location: Norwich, UK Thanks: 2 times
|
Hi
Is switch 1 position 1 set to on? This selects the S/PDIF input rather than the serial (PCM/DSD) input.
Paul N
|
|
|
|
Rank: Member
Groups: Member
Joined: 7/28/2020(UTC) Posts: 3
|
Ahh, there it was! Now its working, many thanks!
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.