Rank: Member
Groups: Member
Joined: 9/6/2016(UTC)
Posts: 16
|
Hi - I've been running my Sennheiser 600 headphones from the Legato out. I have a dual/mono setup and connect the headphones to half the balanced out - SE. The Sennheiser is 300 ohms. I drive it about 3/4 volume for listening.
Is there any advantage of adding a headphone amp? I did find that when I connect a CAT preamp, SE, and dive the headphones from its output, I lose some clarity, but can go louder and get a fuller sound - perhaps it tones down the highs and I increase the volume to compensate and perceive that as "better."
Thanks, John
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
Do you have the buffers installed on the Legato's SE outputs?
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 9/6/2016(UTC)
Posts: 16
|
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
You should be able to use the SE outputs' R+ and L+ as balanced +/- outputs from each Legato. The buffers will provide more than enough current, and you can adjust gain (if needed) in the SE stage of each board.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
