Rank: Member
Groups: Member
Joined: 11/3/2010(UTC) Posts: 169 Location: Quebec
|
Hi Brian, Russ,
I'm using a Arduino (using the latest HiFiduino code) connected to my BII I2C connector and pushing the config to the BII ES9018 chip. Could you please tell me the default parameters that you set in your Eprom so that I can match them?
Filter selection : Sharp or Slow IIR filter : PCM, 50KHz, 60KHz or 70 KHz DPLL bandwidth : Best, Lowest, Low, Low-Medium, Medium, Medium-High, High or Highest Quantizer bit-length : 6-bit True-Differential, 7-bit Pseudo-Differential, 7-bit True-Differential, 8-bit Pseudo-Differential, 8-bit True-Differential NOTCH delay: No Notch, clock/4, clock/8, clock/16, clock/32 or clock/64
I have played with these settings but can seem to get it right... Right now the sound is too soft and lacking detail.
I would really appreciate your help on this.
Thanks Do
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 2,868 Location: Massachusetts, USA
Thanks: 2 times Was thanked: 141 time(s) in 134 post(s)
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.