Rank: Member
Groups: Member
Joined: 11/17/2015(UTC) Posts: 3  Location: Maryland Thanks: 1 times
|
I am using Raspberry Pi I2S output to a 1543 DAC circuit. General opinion is the clock on Raspberry PI is not that good so I would like to try reclocking the three I2S output signals and then send to 1543. Can you confirm the metronome is best product for this as oppose to Chronos reclocker. It appears the Chronos can only handle up to 48K.
Its not a requirement to upsample but rather use the incoming sample rate and reclock to clean up the signal automatically. I am sure I will play with upsampling if it is available and see if there is benefit but not primary requirement. Any configuration advice for PI is also appreciated.
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
The Metronome will work, but not as well as the Cronus. If you want isolation, you would need to either do some surgery on a Hermes if you want isolation, or maybe wait a little while.
BTW: The Cronus is not in any way limited to 48kHz. It will support 384kHz.
|
 1 user thanked Brian Donegan for this useful post.
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
