Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Login
Advice for balanced line driver and receiver for audio transmission
Options
View
Go to last post Go to first unread
Previous Topic Next Topic
LittleLenni  
#1 Posted : Monday, December 22, 2014 12:20:42 PM(UTC)
LittleLenni

Rank: Member

Groups: Member
Joined: 12/22/2014(UTC)
Posts: 3
Germany
Location: Berlin
Hi everybody,

I'm currently looking for a suitable balanced line driver and an according receiver for my Audiocodec project. The Codec has a differential output which I want to prepare with a balanced line driver to send the signal over approx 2 - 3 meters of symmetric, shielded cable (XLR). On the other side of the cable I want to receive that signal, transfer it to an unsymmetric signal and bring it further to my power amplifier.

I took a closer look on the IVY-III I/V Stage but I am a little curious that it is suitable for driving about 3m of cable. Is it capable of doing so or is that the wrong choice for my task?

Any recommandations are highly appreciated. Thank you in advance!

Regards,

Lenni
Back to top

Wanna join the discussion?! Login to your Twisted Pear Audio Support forum accountor Register a new forum account.
Back to top  
LittleLenni  
#2 Posted : Friday, January 2, 2015 9:27:04 AM(UTC)
LittleLenni

Rank: Member

Groups: Member
Joined: 12/22/2014(UTC)
Posts: 3
Germany
Location: Berlin
No Ideas? Could anyone tell me whether I am missing any datasheets or some other document that could tell me what the IVY-III I/V Stage is capable off?
Back to top
Russ White  
#3 Posted : Friday, January 2, 2015 3:34:08 PM(UTC)
Russ White

Rank: Administration

Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 3,979
Location: Nashville, TN

Thanks: 25 times
Was thanked: 89 time(s) in 83 post(s)
It is capable of doing it for sure - but it depend on if your line driver needs a low or a high input impedance.

If you need a high input impedance you could actually adapt the "Retro High Z" to your needs quite nicely. Just omit the filter caps and set the gain you desire.

Cheers!
Russ
Back to top
WWW
LittleLenni  
#4 Posted : Friday, January 2, 2015 4:00:15 PM(UTC)
LittleLenni

Rank: Member

Groups: Member
Joined: 12/22/2014(UTC)
Posts: 3
Germany
Location: Berlin
Hi Russ and thanks for your answer.
My Codec can drive a minimum of 3k Ohms so I assume that is exactly what you said? It needs a high input impedance?!
The receiver is made from an analog devices SSM2141 and has an input impedance of approx 47k Ohms.
Back to top
Rss Feed  Atom Feed
Users browsing this topic
GuestUser (2)
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Youtube
Copyright © Twisted Pear Audio