Rank: Member
Groups: Member
Joined: 6/5/2013(UTC) Posts: 19  Location: Toronto
|
Hi, I've finally got around to putting this together. I'm not sure if it's working correctly.
I've got 13vac going into the relay driver, and 5vdc out of the relay driver into the volumite.
Got the sda/sla (i think) wires hooked up between the volumite and relay driver, and the jumper cable between the relay driver and attenuator.
Is there any sort of troubleshooting documentation on the twisted pear joshua tree?
|
|
|
|
|
|
Rank: Administration
Groups: Administration, Customer
Joined: 10/24/2006(UTC)
Posts: 2,868
Location: Massachusetts, USA
Thanks: 2 times
Was thanked: 141 time(s) in 134 post(s)
|
What do you think is not working?
|
|
|
|
|
|
Rank: Member
Groups: Member
Joined: 6/5/2013(UTC) Posts: 19 Location: Toronto
|
Ok, I looked at it again today and verified I have 13vac going into the relay driver. I'm coming out of the relay driver with +5v & gnd into the volumite ok.
I've got SCL and SDA connected between the volumite and relay driver. I don't hear any relays triggering when I turn the pot.
What should I be looking for on the output of SCL / SDA from the volumite? I should check that to start with.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
