Rank: Member
Groups: Member
Joined: 12/27/2012(UTC) Posts: 6
|
I have mounted BuffaloIII-SE with two entries:
SPDIF Hiface I2S Amanero.
At begin the two inputs are equal, but after several days of use, I2S signal now comes with an attenuation of 8 dB over the same SPDIF signal
Just is the same in I2S Amanero and I2S Luckit.
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 3,979 Location: Nashville, TN
Thanks: 25 times Was thanked: 89 time(s) in 83 post(s)
|
8db is a strange number... That does not make any sense.
Pictures might help us spot a problem, or it could be something at the source.
|
|
|
|
Rank: Member
Groups: Member
Joined: 12/27/2012(UTC) Posts: 6
|
Thank you for your answer.
Located the problem. The failure occurred by the clock power suply. I not exactly know how this -8 dB attenuation occurs. It is when the value deviates 3.3 v. to 3.28 v. It seems that with these 3.28 v. the problem was produced.
I have reviewed the solders and now is OK 0 dB. I will see if the value deviates again 3.3 v. to 3.28 v. after many days ON or was a bad contact only.
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 3,979 Location: Nashville, TN
Thanks: 25 times Was thanked: 89 time(s) in 83 post(s)
|
Hmm, I think you likely have found the problem, but I doubt it was actually the .02V difference itself that cause it. That sounds coincidental. Likely it was just a cold joint some place.
|
|
|
|
Rank: Member
Groups: Member
Joined: 12/27/2012(UTC) Posts: 6
|
It´s something strange.
Without touching anything happened after two days continuously ON. And the only place I've reviewed solders is on that power suply.
I've reproduced putting a different source adjusted to 3.28 v.
It also might be doing something wrong. 8 <((.
Thank you very much for your attention.
|
|
|
|
Rank: Administration
Groups: Administration, Customer Joined: 10/24/2006(UTC) Posts: 3,979 Location: Nashville, TN
Thanks: 25 times Was thanked: 89 time(s) in 83 post(s)
|
That sounds very much like a power sequence issue.
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.